Projecten

broken stay bolt m 85

this broken stay bolt was broken  insite the engine of a container ship with a length of 335 meters long.

we removed it by spark erosion it took us 18 hours to get it out.

Bekijk project

Esmaly-Works was called on a Sunday morning. The client asked us off it was possible to remove a broken M 50 .

the bolt was broken 30 cm below the surface. it took us several hours to remove it with our technique. We did the job 

Bekijk project

Esmaly-works was called by a client. this man had a problem he broke his tap m3 in a fuel tank of his motor cycle. it was a Triumph TA from 1958. he asked of it was possible for us to remove it.

Bekijk project

Esmaly-Werken was called on a Friday night to remove a broken stud bolt M110x6 from a main 
engine of one of the world's largest container ships. This was a Wärtsilä engine. The ship
 was in Antwerp. We came on board and finished the job in 8 hours. This is partly due to our

Bekijk project

The crane needed to be transported to Amsterdam from Belgium to fix. We fixed it on location instead.

Bekijk project

 

Broken exhaust valve bolts Volvo shovel.

Bekijk project

While dismantling the stabilizer of the truck a bolt broke down. They tried to heat it and remove it, during which the metals hardened making drilling impossible. We eroded the bolt, making a square hole so that they could remove the bolt very easily.

Bekijk project

M46 bolt broke off a gasstanker in Norway. It took us about 9 hours to remove the bolt on location.

Bekijk project

The extra counterweights are closer to the ground. That is where the M16 bolts regularly break off. With our eroding technique you will make up for lost time replacing them.

Bekijk project

They tried the drill out the bolt, which had no results. We sparked the bolt and removed it on location.

Bekijk project

We remove small and big bolts. We also assist in removing bolts for car bodies.

Bekijk project

A broken bolt from a Rolls Royce gas turbine engine with a size of m46. This was 150mm deep into the engine block and right next to the cylinder wall. Because we are specialised in spark erosion machinery and we do the job with a special electrode.

Bekijk project

This vessel was for maintenance in the harbour and the client called esmaly-werken for this job.We came on board and erode a squire hole in the broken piece , after that we mount a special tool in it and twist the broken piece out of the engine.

Bekijk project

Eroding turntable screws of a 100 ton Terex crane.

Bekijk project

Eroding a broken contra-weight bolt of a linde motrac container truck. This M36 bolt was in 34 cm deep with a hardness of 12.9. The tools for removing were placed 80 cm from the broken bolt.

Bekijk project